Presta Products
Step #1 Ultra 2 Step® Cutting Compound
Presta's Ultra 2 Step Buffing System was designed to simplify the buffing process, saving you time and money while delivering unparalleled results. This advanced system features water-based products that contain no waxes, fillers or silicones.
Start with the advanced Ultra 2 Step Cutting Compound to remove 1200 grit and finer sand scratches from both new and aged paint. The Ultra 2 Step Compound has been designed to work effectively with both wool and foam pads and over a wide range of buffing speeds.
- Fast cutting compound optimized to remove medium to heavy sand scratches
- Water-based formula contains no waxes, fillers or silicones
- Works easily over a wide range of buffing speeds and finishes clean
Complete the process by following with Ultra 2 Step Finishing Polish.
Step #2 Ultra 2 Step® Finishing Polish
Presta's Ultra 2 Step Buffing System was designed to simplify the buffing process, saving you time and money while delivering unparalleled results. This advanced system features water-based products that contain no waxes, fillers or silicones to hide or cover up scratches and imperfections.
Ultra 2 Step Finishing Polish significantly reduces buffing time when used after Ultra 2 Step Cutting Compound.
Designed for use on both new and aged clear coat paint surfaces. This advanced formula creates a rich, deep gloss and a swirl-free finish in a single step. It is easy-to-use and easy-to-clean-up.
- Advanced all-in-one polish and swirl remover
- Water-based formula contains no waxes, fillers or silicones
- Creates deep gloss and swirl-free final finish
Metal Flake Application: "Dry Flake"
Apply our Metal Flakes over any base color to produce a real custom effect, most customers use a black Basecoat. We recommend adding the Metal Flake to our Flake Carrier but you can add them to a Automotive solvent or water based Clearcoats, Clear basecoats and Resin's. Depending on how heavy you want the flake effect, will depend on how much you will need.
Always spray test panels before spraying you product or project to see the effect you desire.
- Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
- Apply 2-3 coats of Base coat.
- Add 5g to 100g of Dry Metal Flake to a Clear base coat or lacquer and stir well.
- Apply the 1 - 5 coats of Metal Flake until you get the effect you desire.
- Apply a Clearcoat until the Metal Flake is fully covered.
Metal Flake Fx Application: "Paint"
METAL FLAKE FX is an EASY to apply Metal Flake paint. Metal Flake FX is highly concentrated with our Metal Flake and full coverage can be achieved with in a few coats, which then can be 2K clear coated or be used as a base for our Candy effect paints.
- Always spray test panels before spraying your product or project.
- Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
- Apply 2-3 coats of Basecoat leaving 10-15 minutes between coats.
- Leave 60 minutes before applying the effect color to ensure basecoat is fully dry.
- Stir paint well before adding Reducer. Mix Metal Flake Fx 2-1 with Reducer & stir well.
- Apply 2-5 coats of Metal Flake Fx depending on the effect you desire. Leave 20-30 minutes between coats. Ensure its fully
- Leave 60 minutes before applying a 2k Clearcoat.
