Inspire H2O Passion

$8.95
/

Description:

PASSION H2O brings you a smooth free flowing colour change ( Flip paint ) unlike any other coating seen before. For the most dramatic effect Passion is applied over a black base coat but can be applied over a lighter base coat for a softer iridescent look yet still intense color change. The color possibility is endless and brings a new dimension to your product.

The Inspire Airbrush range are twice the strength as our custom paint range. This is to help reduce the amount of coats needed for the airbrush artist. All colors come ready to use.

Passion H2O colors:

  • GREEN PASSION shifts from a Green Turquoise to a bright Silver to a Red and Gold.
  • KIWI PASSION shifts from a Green to Silver to Red to Orange.
  • TROPICAL PASSION shifts from a Gold to Silvery Green to Deep Blue.
  • DESERT PASSION shifts from a Pinky Red to Gold to Green.
  • PURPLE PASSION shifts from a strong Purple over Silver and Green to Blue.
  • BLUE PASSION shifts from a Turquoise to Blue to Purple.



Metal Flake Application: "Dry Flake"

Apply our  Metal Flakes over any base color to produce a real custom effect, most customers use a black Basecoat. We recommend adding the Metal Flake to our Flake Carrier but you can add them to a Automotive solvent or water based Clearcoats, Clear basecoats and Resin's. Depending on how heavy you want the flake effect, will depend on how much you will need.

Always spray test panels before spraying you product or project to see the effect you desire.

  • Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
  • Apply 2-3 coats of Base coat.
  • Add 5g to 100g of Dry Metal Flake to a Clear base coat or lacquer and stir well.
  • Apply the 1 - 5 coats of Metal Flake until you get the effect you desire. 
  • Apply a Clearcoat until the Metal Flake is fully covered.

Metal Flake Fx Application: "Paint"

METAL FLAKE FX is an EASY to apply Metal Flake paint. Metal Flake FX is highly concentrated with our Metal Flake and full coverage can be achieved with in a few coats, which then can be 2K clear coated or be used as a base for our Candy effect paints.

  • Always spray test panels before spraying your product or project.
  • Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
  • Apply 2-3 coats of Basecoat leaving 10-15 minutes between coats.
  • Leave 60 minutes before applying the effect color to ensure basecoat is fully dry.
  • Stir paint well before adding Reducer. Mix Metal Flake Fx 2-1 with Reducer & stir well.
  • Apply 2-5 coats of Metal Flake Fx depending on the effect you desire. Leave 20-30 minutes between coats. Ensure its fully 
  • Leave 60 minutes before applying a 2k Clearcoat.

This site is protected by hCaptcha and the hCaptcha Privacy Policy and Terms of Service apply.

You may also like

Recently viewed