2K Clearcoat Kustom Canz
2K Clearcoat CANZ:
THIS CAN NEED TO BE ACTIVATED
Custom Paints brings you 2K Clearcoat in an aerosol can. The 2K aerosol is a brand new design unlike any other aerosol on the market. It's a better design than any other giving high output with excellent Atomization and high transfer efficiency with no pressure drop during application. Using our 2K Clearcoat CANZ can save on time and labor with no mixing or Spray Gun cleaning. 2K Clearcoat CANZ have good flow giving a great high gloss finish.
2K Clearcoat CANZ is a great product for Vehicle Spot repairs and small jobs that require High Gloss with strength and toughness of an Automotive Clearcoat.
2K Clearcoat CANZ Performance:
- 2-Component Technology (in-can activator system)
- High Gloss providing high scratch resistant
- Spray gun finish
- Quick drying time
- Excellent flow
- Easy polishing
- 24 hour pot life
- Particularly suitable for Vehicle Spot repair
APPLICATION:
- Remove grey cap at base of can and insert metal ring into the pin provided.
- Pull pin fully out and twist 360 degrees to release activator.
- Shake Custom Aerosol Can for 2-5 minutes.
- Apply 2-3 coats of Clearcoat leaving 5-10 minutes between coats.
- Drying time 30-60 minutes depending on temperature.
- Infrared compatible.
- Can be mechanically polished after 24 hours.
- After use turn aerosol can upside down and empty valve.
- Pot life of up to 24 hours at 20 degrees C / 68 Fahrenheit.
Metal Flake Application: "Dry Flake"
Apply our Metal Flakes over any base color to produce a real custom effect, most customers use a black Basecoat. We recommend adding the Metal Flake to our Flake Carrier but you can add them to a Automotive solvent or water based Clearcoats, Clear basecoats and Resin's. Depending on how heavy you want the flake effect, will depend on how much you will need.
Always spray test panels before spraying you product or project to see the effect you desire.
- Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
- Apply 2-3 coats of Base coat.
- Add 5g to 100g of Dry Metal Flake to a Clear base coat or lacquer and stir well.
- Apply the 1 - 5 coats of Metal Flake until you get the effect you desire.
- Apply a Clearcoat until the Metal Flake is fully covered.
Metal Flake Fx Application: "Paint"
METAL FLAKE FX is an EASY to apply Metal Flake paint. Metal Flake FX is highly concentrated with our Metal Flake and full coverage can be achieved with in a few coats, which then can be 2K clear coated or be used as a base for our Candy effect paints.
- Always spray test panels before spraying your product or project.
- Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
- Apply 2-3 coats of Basecoat leaving 10-15 minutes between coats.
- Leave 60 minutes before applying the effect color to ensure basecoat is fully dry.
- Stir paint well before adding Reducer. Mix Metal Flake Fx 2-1 with Reducer & stir well.
- Apply 2-5 coats of Metal Flake Fx depending on the effect you desire. Leave 20-30 minutes between coats. Ensure its fully
- Leave 60 minutes before applying a 2k Clearcoat.