1K Primer Kustom Canz
Kustom Canz 1K Primer:
Kustom Canz 1K Primer is a premium primer-surfacer for fast spot priming providing a smooth pin hole free surface easily sanded. Can be used directly onto many difficult substrates including alloy, stainless steel, zintec and galvanize.
1K Primer Colors:
- Black
- Grey
- White
1K Primer Performance:
- Excellent adhesion and anti-corrosive properties
- Quick Drying-time
- Spray gun finish
- Excellent smooth surface finish
- Particularly suitable for Vehicle Spot Repair
APPLICATION:
- Remove all rust from metal surfaces.
- Clean surface with a suitable degreaser then abrade.
- Areas to be sprayed must be free of grease, dust and dry.
- Shake aerosol can for at least two minutes, after agitator ball is free.
- Carry out test spray before spraying your project.
- Apply 1-2 coats wet coats.
- Leave 10-15 minutes between coats.
- Drying time 30-60 minutes Air Dry at 20C, 3 minutes Infrared.
- After use, turn aerosol can upside down and spray to clear the valve.
Metal Flake Application: "Dry Flake"
Apply our Metal Flakes over any base color to produce a real custom effect, most customers use a black Basecoat. We recommend adding the Metal Flake to our Flake Carrier but you can add them to a Automotive solvent or water based Clearcoats, Clear basecoats and Resin's. Depending on how heavy you want the flake effect, will depend on how much you will need.
Always spray test panels before spraying you product or project to see the effect you desire.
- Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
- Apply 2-3 coats of Base coat.
- Add 5g to 100g of Dry Metal Flake to a Clear base coat or lacquer and stir well.
- Apply the 1 - 5 coats of Metal Flake until you get the effect you desire.
- Apply a Clearcoat until the Metal Flake is fully covered.
Metal Flake Fx Application: "Paint"
METAL FLAKE FX is an EASY to apply Metal Flake paint. Metal Flake FX is highly concentrated with our Metal Flake and full coverage can be achieved with in a few coats, which then can be 2K clear coated or be used as a base for our Candy effect paints.
- Always spray test panels before spraying your product or project.
- Start by prepping your project as you would any other paint job. (Sand, Prime, etc.)
- Apply 2-3 coats of Basecoat leaving 10-15 minutes between coats.
- Leave 60 minutes before applying the effect color to ensure basecoat is fully dry.
- Stir paint well before adding Reducer. Mix Metal Flake Fx 2-1 with Reducer & stir well.
- Apply 2-5 coats of Metal Flake Fx depending on the effect you desire. Leave 20-30 minutes between coats. Ensure its fully
- Leave 60 minutes before applying a 2k Clearcoat.